Remove oil fi lter (A) located at the back left side
of the engine. Turn fi lter counterclockwise to
remove.
A
Wipe the fi lter mounting surface clean with a
clean cloth.
Apply a thin fi lm of clean engine oil to gasket of
oil fi lter.
Install new fi lter. NOTE: Turn fi lter clockwise
until fi lter gasket makes contact with the mount-
ing surface. Tighten 1/2 - 3/4 turn after gasket
contact.
Install oil drain cap. DO NOT over-tighten.
Remove oil fi ll cap
Add oil to engine. (See Engine Operator’s manu-
al for proper oil and capacity)
Install oil fi ll cap.
Start engine and allow to run at slow idle for ap-
proximately 2 minutes.
Shut off engine.
Remove ignition key from switch.
Check oil after allowing engine to cool for ap-
proximately 2 minutes. (Refer to “Checking
Engine Oil Level” for proper procedures on how
to check the oil).
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
C
LEANING
A
IR
I
NTAKE
S
YSTEM
Adequate airfl ow is a key part of proper operation
for this machine. Air intake primarily comes from
the rear screened hood of the machine. Proper air-
fl ow can become restricted by debris such as grass,
and leaves. If rear screened hood accumulates a
signifi cant amount of debris, follow the steps below
to clean screen.
AVOID PERSONAL INJURY!
Wear personal eye protection when using
compressed air or water for cleaning purposes.
ATTENTION: Avoid damage to your engine!
Air intake screens must be clean to prevent
the engine from overheating and to allow
adequate air fl ow.
Park machine on a level surface.
Shut off engine and engage park brake.
Remove ignition key from switch.
Allow engine to cool.
Open up rear hood screen to access the inside of
the air intake screens.
Clean all debris from outer screens (A) around
the hood with a brush, compressed air or water.
NOTE: Be sure to blow or spray from the inside
out.
Inspect and clean radiator screen if necessary
(B).
A
1.
2.
3.
4.
5.
6.
7.
SERVICE - ENGINE
Service - 24
B
https://www.tractormanualpdf.info/
