SERVICE
Service - 46
7. Connect the negative (-) booster cable to the
booster battery’s negative (-) terminal (3).
8. Connect the other end of the negative (-) booster
cable to the disabled power unit’s ground stud (4).
9. Start the disabled power unit and remove the
booster cables in reverse order of installation
(negative booster cable first).
TCM (Tractor Control Module) Explanation
A
The Tractor Control Module (A) is a sealed computer-
ized device designed to control the electronic safety
related functions of this tractor. Both solid state and
mechanical components are used to assure safe,
reliable operation of this machine.
This TCM monitors the electronic circuits necessary
for the engine, starter, and PTO to function. These
“input” circuits include the PTO Switch, Neutral Switch,
Parking Brake Switch, Key Switch, Seat Switch, and
Generator Presence. The TCM is programmed to
allow the engine, starter, or PTO to operate only when
specific input criteria are satisfied. The engine, start,
and PTO are controlled by “outputs” from the TCM.
For additional information, refer to the TCM section
of the troubleshooting guide.
Replacing Fuses (Power Relay Module)
1. Park the power unit on a level surface.
2.
Engage the parking brake and shut off the engine.
3. Remove the key from the ignition switch.
4.
Turn the battery disconnect switch to the Off
position.
A
B
5. Open the left hood
panel.
6. Remove the sealed
fuse cap from the
power relay module.
7. Identify and pull the
defective fuse from the
socket.
8.
Power Relay module (J-Case Fuse)
Position
Fuse
Circuit
Top (A)
50 amp
Rear Fuse Panel Supply
Bottom (B)
50 amp
Key Switch, TCM
Insert a new fuse into the socket. Be certain to
use the correct amperage fuse or damage may
occur to the power unit.
9. Reinstall the sealed fuse cap and close the left
hood panel.
10. Turn the battery disconnect switch to the On
position.
Replacing Fuses (Front Fuse Panel)
1. Park the power unit on a level surface.
2.
Engage the parking brake and shut off the engine.
3. Remove the key from the ignition switch.
4.
Turn the battery disconnect switch to the Off
position.
A
5. Tilt the seat forward and
remove the front canvas.
6. Remove the sealed cover
(A) from the fuse panel.
Front Fuse Panel (Mini Fuse)
Position
Fuse
Circuit
1
15 amp
PTO
2
5 amp
Gauges & Alarm
3
5 amp
Seat Switch
4
15 amp
Head / Tail Lights
5*
20 amp
12v Rear
6*
15 amp
Work / Strobe Lights
7*
10 amp
Back-up / Horn / Directional
8*
15 amp
12v Front Relays
9*
5 amp
12v Front Controls
10*
10 amp
Hydraulic Auxiliary
*Optional accessory.
7. Identify and pull the defec-
tive fuse from the socket.
