SERVICE
Service - 38
8.
Remove the oil filter (B) located on the side of the
engine. Turn the filter counterclockwise to remove.
9.
B
Wipe the filter mounting surface with a clean cloth.
10.
Apply a thin film of clean oil to the gasket of the
new oil filter.
11.
Install the new filter turning it clockwise until the
gasket makes contact with the mounting surface.
Tighten the filter 1/2 to 3/4 turn more by hand.
12. Install the drain cap onto the oil drain. DO NOT
over-tighten.
13.
Remove the oil fill cap.
14. Add oil to the engine. (Refer to Engine Owner’s
Manual for proper oil specifications and capacity.)
15.
For optimal engine life
and performance, use
Ventrac Full Synthetic
Engine Oil.
Part # 15.0037-1
Attention: Engine Oil Recommendation
ENGINE OIL
SAE 10W-30
Premium Full Synthetic
Install the oil fill cap and wipe up any oils spills.
16. Start the engine and run at slow idle for approxi-
mately 2 to 3 minutes.
17.
Shut off the engine and remove the ignition key.
18.
Check for oil leaks around the oil filter.
19. Check the engine oil level after allowing the
engine to cool for approximately 2 minutes. Add
oil, if necessary.
20. Replace the top hood panel.
Inspecting & Resetting The Air Filter
Restriction Gauge
The air filter restriction gauge (A) is located on
the air filter canister outlet to the engine. It can be
viewed by looking between the air intake baffle and
the exhaust baffle.
A
To check the air filter restriction gauge:
1. Park the power unit on a level surface.
2.
Engage the parking brake and shut off the engine.
3. Remove the key from the ignition switch.
B
C
4. Remove the rear panel.
5. Check the inspec-
tion window (B) on
the restriction gauge.
When the air flow
restriction reaches the
set limit, the inspection
window will turn red
to indicate the air filter
must be replaced.
6. After replacing the
primary air filter, reset
the filter restriction
gauge by pressing the button (C) on the top of
the gauge.
7. Replace the rear panel.
