SECTION E
SERVICE SCHEDULE
E-1
VENTRAC 3000
VPI
Service Schedule
The operator’s manual and decals should be read and understood before operating the machine or
attachments. This manual should be reviewed periodically or when in doubt about any function,
procedure, or safety factor on this equipment.
Daily
Check the oil and water levels (liquid cooled engines only) daily in the engine. Fuel level needs to be
checked every couple hours. When working on slopes, keep a minimum of 1/4 tank of fuel. Flywheel
or radiator screen and air intake filter should be checked frequently when working in a dirty
environment. Clean or change as needed. Keep equipment clean. Accumulated debris can restrict
performance, cause equipment failure and be a safety hazard.
Visual
Many equipment conditions are visible before operation. For example, an oil leak, low tire inflation,
obstructed flywheel screen, loose or missing hardware, shields or a broken belt. These should be
repaired or replaced before operation!
Some equipment conditions are not evident until operation. For example, a failing bearing, broken
electrical wire, faulty switch or loose part. These should be corrected as soon as evident. Operation
should cease immediately if an unsafe condition is observed!
Operators should always be alert for potential problems. Personal safety and the safety of others as
well as the performance of the equipment depend on the operator’s care and repair of the machine and
continuous caution and control of the same.
Engine Oil and Filter Change
Kawasaki — Initial change at 8 hours and every 100 hours thereafter.
Note: refer to engine manual for further details.
Transaxle Oil and Filters
Change oil and oil filter only if the system has been contaminated. Check oil levels every 100 hours.
If there is an oil leak or new attachments have been used that require “priming”, the front transaxle oil
level should be checked at that time.
Storage
Drain fuel tank, check for proper tire inflation and remove battery.