Upper Housing
Yoke
5. Install the upper housing by threading the power leads and fix six screws.
- 4 -
- 9 -
Screws
V. CODE SWITCH SETTING
1.
2.
3.
4.
5.
6.
These DIP code can be pushed upward and downward to change the setting.
Both of these remote control components (receiver and transmitter) have a set of four
switches that need to have the same settings. (The total combination becomes 16
frequency codes).
The setting determines the frequency that will be used to control the ceiling fan.
Otherwise, the ceiling fan will not operate.
Once the setting has been made, slide down the back cover of transmitter to the arrow
direction. Install a 9 Volt battery.
Now the remote control receiver module is ready for installation up at the ceiling fan
of mounting bracket.
Select different combinations of dip switches to prevent mis-operation due to other
remote control fans.
RECEIVER
ANTENNA
9V BA
TTER
Y
1 2 3 4
ON DIP
DIP SWITCH
Follow the arrow direction to
open the battery cover.
4.
The mounting bracket must be securely fastened to a structural ceiling member.
NOTE:
a.) Please choose one of the following ways to install the mounting bracket.
b.) Make sure all screws are tightened.
Mounting Bracket
Expansion Screw ( h.)
Nut ( h.)
Clasp ( j.)
Mounting Bracket
Screw ( i.)
Clasp ( j.)