- 10 -
- 3 -
RED
(Mains/Live)
WHITE
(Mains/Neutral)
AC POWER INPUT
BROWN
(Fan/Live)
BLUE
(Fan//Neutral)
BLACK
(ANTENNA)
GREEN/YELLOW
(Ground Wire)
Take out parts and accessories from the Styrofoam box, except the fan body. Place
the motor onto the Styrofoam box with wires facing the ceiling.
Align the holes of the blade to the holes on the fan body. Then put the washer through
the screws and tighten screws. Repeat the same action for the other four blades. As
for the bottom of the blades tighten screws only after the fan is hanging onto the
mounting bracket.
2.
3.
Floor
2.3m
Blade Screws
Washers
CODE SWITCH
ANTENNA
(Do not attempt to shorten
the receiver’s antenna wire.)
COMPLETE DIAGRAM
Fig 2
1.
ATTENTION:
Do not install the fan onto the partition ceiling or chapped wall.
The ceiling fan must be mounted at a min. height of 7.5ft/2.3m of clearance from the
floor.
III. INSTALLATION INSTRUCTION
VI. WIRING FOR CEILING FAN INSTALLATION
NOTE:
a.) Incorrect wire connection may damage this fan and receiver.
b.) Do not attempt to shorten the receiver’s antenna wire.
1.
2.
3.
4.
5.
A typical ceiling fan remote control is wired as shown in this wiring diagram. (Fig. 1)
Make sure that the wire of brown/blue/orange is connected.
Wires connecting the receiver and the ceiling fan have its sticker indication. The
receiver wires to the fan motor are Blue (neutral) marked TO MOTOR N and
Brown (live) marked TO MOTOR L.
Connect wires with sticker indicating “AC IN” from the receiver-Red (live) and
White (neutral) to the wires from the ceiling.
Make sure that the ground wire from the ceiling is connected to the GREEN/YELLOW
wire of the ceiling fan.
After connecting the wires, push up the canopy till it reaches the ceiling then install
the receiver by sliding into opening in the mounting bracket. Tighten the canopy screw.
As shown in Fig.2
N / WHITE
L / RED
GROUND WIRE
(GREEN/YELLOW)
GROUND WIRE
(GREEN/YELLOW)
N / BLUE
L / BROWN
Fig 1
CEILING FAN
AC
POWER
INPUT
N / BLUE
L / BROWN
TO MOTOR N
/
BLUE
TO MOTOR L
/
BROWN
ANTENNA
TO FAN
Wiring place
AC IN
Wiring place
Fuse socket
N
L
L
N