26
Appendix II: Maintenance by the end user
This appendix provides you, as an end user, information about the maintenance of your unit.
Cleaning/replacing the filters
Make sure you carefully follow all steps from section 3.3 of the scheme on the next page when performing
maintenance on the filters. When performing maintenance in any other way, the warranty expires.
Recommendations for checking/cleaning/replacing the filters:
-
Before commissioning of the unit
-
The first six months every one to two months
-
After this every three months
-
You can keep track of the date when you replaced the filters in the table on page 32
Check operation of the Aquacom unit
To ensure the correct operation of the Aquacom, there are several simple things you can do while
cleaning/replacing the filter. If you note a problem while performing the following actions, contact your
installer.
-
Check whether the manometer shows the correct pressure. This should be between 0.8 and 1 bar
-
Check whether the flow meter shows a flow. Make sure the pump is turned on. Watch out for the wiring
and possible parts through which current might be flowing! If the pump is inactive, use the function pump
test as described in section 3.1 submenu 4. The flow should amount 6 l/min. If the pump is active and
there is no flow, check whether the main valve and the valve on the flow meter are open. Call the installer
when the pump is defect
-
Check for leakages/damages
It is very important to check the filters of your ventilation equipment regularly for contamination, to clean
them and/or replace them. To make this even simpler, we offer you one free G4 filter. The only thing you
have to do is send an email to
e-Mail subject:
Free Aquacom filter
State in your mail:
- The units serial number (located on a sticker on the side of the
unit)
- The data of the installer where you bought the unit.
- Your name and address where we can send the filter.
Summary of Contents for Comair Aquacom
Page 1: ......