www.ventev.com/infra
800-851-4965
2.4/5 GHz 6 dBi Omnidirectional Wi-Fi Light Globe Antenna
with 4 RPSMA Plugs for LED Light Globes
Note: These procedures assume the Heat Sinks have been pre-drilled to host the antenna Stand-Offs, and the center hole in
the bottom of the cast metal base has been enlarged to fit the antenna connectors.
1. Select a Printed Circuit Board (PCB). Insert the PCB’s cable and connector between the heatsink extrusions to the
right side of the antenna being installed and down thru the 1.0” diameter hole in the center plate. Refer to Image
item #1.
2. Using the plastic screws and spacers provided, carefully mount the PCB antennas to the heatsinks. Using caution
not to bend the PCB or overtighten the plastic screws. Refer to Image item #2.
3. Repeat for the remaining 3 PCBs.
4. Dress the cables to remove any excess slack from above the mounting plate using caution not to kink the cable or
exceed a 1” bend radius. Zip-tie the cables to provide strain relief. Refer to Image item #3.
Installation Instructions
