11126 McCormick Road, Hunt Valley, MD 21031 | 800-851-4965 | [email protected] | ventevinfra.com |
Rev. 022822
9
Warning!
DO NOT lift the Hazardous Environment Enclosure using the threaded entries, N-type
RF connectors, or door bolts. Lift only using suitably approved slings, fitted by suitably
qualified personnel.
Warning!
When a device is fitted with a coin cell and the coin cell is required to be replaced, it
shall only be fitted with the exact same type of coin cell as marked on the device.
Warning!
The Hazardous Environment stainless steel enclosure weighs approximately 70Kg.
Exercise care when handling and use suitable mounting points and structures. Mount
the enclosure ONLY using the mounting points shown.
Important
Always re-apply a thin layer of Loctite 8104 or Loxeal GS9 silicone grease to the
enclosure flame paths whenever the Hazardous Environment flameproof enclosure is
opened. This is required to maintain the IP rating of the enclosure.
Important
Do not exceed the power supply parameters specified on the Hazardous Environment
Enclosure external rating plate.
Important
Ensure that NO TOOLS come into contact with the flamepath of the enclosure, as this
may cause irreparable damage and render the unit unsafe.
Important
Ensure that only the correct fiber transceiver format/power is connected to the
Hazardous Environment Enclosure. Damage to the Hazardous Environment Enclosure
fiber interface or customer equipment may occur if the wrong format/excessive optical
power is used.
Important
Only replace the fuse with the same value and type indicated on the internal fuse
identification label.
