11126 McCormick Road, Hunt Valley, MD 21031 | 800-851-4965 | [email protected] | ventevinfra.com |
Rev. 022822
7
Warning!
Installation of the Hazardous Environment Enclosure must be performed in accordance
with IEC 60079-14 and IEC 60079-25. Maintenance and inspection must be performed
in accordance with IEC 60079- 17.
Warning!
Installation of the Hazardous Environment Enclosure is only to be performed by skilled
electricians and instructed personnel in accordance with national legislation.
Warning!
The Hazardous Environment Enclosure contains INTRINSICALLY SAFE circuits.
Warning!
The Hazardous Environment Enclosure Intrinsically Safe RF output ports are located in
the positions shown in Section 3.3. Only antennas in accordance with Section 3.11 may
be connected to these ports. Refer to Section 3.12 for antenna installation requirements.
Warning!
The Hazardous Environment Enclosure MUST be earthed. Refer to Section [earthing] for details.
Warning!
The Hazardous Environment Enclosure must NOT be installed in hazardous areas
requiring Category 1, M1, or M2 equipment.
Warning!
Although antennas connected to the Intrinsically Safe RF outputs of the Hazardous
Environment Enclosure may be installed in hazardous areas requiring Category 1
equipment, the Hazardous Environment Enclosure flameproof must NOT be installed
in these environments.
Warning!
The Hazardous Environment flameproof enclosure must NOT be opened when an
explosive gas or dust atmosphere is present or when the equipment is energized.
Warning!
The Hazardous Environment flameproof enclosure lid must be secured only with the
bolts supplied and these must be tightened to the correct torque value. See Section
3.2.2 for details. Contact Ventev for spare bolts.
