4
Timer Adjustment.
The overrun time period is factory set to 15 minutes. The overrun time period may be adjusted from 5-25 minutes,
by altering the adjuster on the back of the Control Timer.
Before adjusting the timer, switch off the Mains Supply.
1. Remove the Controller Unit.
2. To REDUCE the operating time, turn the adjuster ANTI-CLOCKWISE on the back of the Controller.
3. To INCREASE the operating time, turn the adjuster CLOCKWISE on the back of the Controller.
4. Replace the front of the Control Timer.
5. Reconnect the mains supply.
C.
SERVICING AND MAINTENANCE.
WARNING:
THE FAN AND ANCILLARY CONTROL EQUIPMENT MUST BE ISOLATED
FROM THE POWER SUPPLY DURING MAINTENANCE.
BULB REPLACEMENT
Disconnect the power supply, and be sure that the lamp has fully cooled before removing or replacing.
Replace any cracked or damaged lamp
Remove the faulty lamp by pulling it out the lamp housing.
Replace new lamp by aligning the 2 lamp pins with the lamp holder in the lamp housing and then pushing it into position
.
Use only a 3W LED 12VDC Lamp, Type MRI6
MAINTENANCE
Disconnect the power supply
The shower light bezel can be removed and cleaned with a cloth.
The shower light housing and inline fan can be cleaned with a cloth.
It is recommended to check the electrical connections annually
.
The Lo-Carbon fan has sealed for life bearings, which do not require lubrication.
Head Office: Fleming Way, Crawley, West Sussex, RH10 9YX.
UK NATIONAL CALL CENTRE
, Newton Road, Crawley, West Sussex, RH10 9JA
SALES ENQUIRIES:
Tel: 0844 8560590
Fax: 01293 565169
TECHNICAL SUPPORT:
Tel: 0844 8560594
Fax: 01293 539209
For details of the warranty and returns procedure please refer to www.vent-axia.com or write to Vent-Axia Ltd, Fleming Way, Crawley, RH10 9YX
404177A
0213
The
Guarantee
Applicable only to products installed and used in the United Kingdom. For details of guarantee outside the United Kingdom contact your local
supplier.
Vent-Axia guarantees its products for two years from date of purchase against faulty material or workmanship. In the event of any part being found
to be defective, the product will be repaired, or at the Comp
any’s option replaced, without charge, provided that the product:-
Has been installed and used in accordance with the instructions given with each unit.
Has not been connected to an unsuitable electricity supply. (The correct electricity supply voltage is shown on the product rating label
attached to the unit).
Has not been subjected to misuse, neglect or damage.
Has not been modified or repaired by any person not authorised by the company.
IF CLAIMING UNDER TERMS OF GUARANTEE
Please return the complete product, carriage paid to your original supplier or nearest Vent-Axia Centre, by post or personal visit. Please ensure
that it is adequately packed and accompanied by a letter clearly marked “Guarantee Claim” stating the nature of the fault and providing evidence of
date and source of purchase.
The guarantee is offered to you as an extra benefit, and does not effect your legal rights
controller