Electric TV Lift, TS600B
6
5. Installation
1) Remove all contents from packaging and compare with parts list.
2) Place the lift unit (#1) onto your straight mounting surface e.g. the back panel of the cabi-
net* in a location that will allow full up and down movement of the lift.
3) Connect the plug from lift unit (#1) to the
TV lift output port
of the control box (#4), rocker
switch (#2) to the
Input
port and the power supply (#5) to the
DC Input
port of the control
box (#4) like shown below.
4) To mount the lift onto your own board or flat wall with normal screws, first screw through
the 2 lower brackets using suitable screws. Place a rubber washer ( #3 ) between each
bracket and the mounting surface. Then run the lift to its top position using the rocker
switch. Then repeat the screw fixing for the 2 upper brackets.
5) If using the M5 threaded hole for mounting then screw into this from the back side of your
mounting board with suitable length Allen screws, when using these holes you will not
need to raise the lift to secure to the upper brackets. Place a rubber washer ( #3 ) be-
tween each bracket and the mounting surface.
6) Mount rocker switch (#2) in an easy location by cutting a ø30 hole and pressing the
switch into place. Secure excess wire to keep away from moving parts.
7) Plug the power cord ( #6 ) into main electrics and operate manual rocker switch. If the op-
tional RF or IR transmitter has been purchased, the control box needs to be linked to the
transmitter before use. See troubleshooting guide on
, click “support”.
Helpful hint:
Mount TV lift and electronics to a plywood panel and attach to inside back of cabi-
net using appropriate number of screws. This allows all components to be removed from the cab-
inet if necessary. If this is not possible, create an access panel to the electronics.
* Aim to create easy access for wear and tear replacement stroke service.
Optional RF emitter R315290
Optional IR eye and emitter R137380
To code the RF or IR see page 11
