Close the drug cabinet door, ensuring no penetration of light. The Venner
DruGuardian
™
is now active.
To test the device is working, open the drug cabinet door and ensure no
movements in front of the cupboard. After a delay the alarm should trigger.
To stop the alarm either move in front of the cupboard or close the door.
During normal operation Venner DruGuardian
™
will monitor and record activity
in front of the open drug cabinet. If the drug cabinet is abandoned for a period of
time (determined by the alarm delay rotary switch), the alarm will initially emit
an intermittent beeping sound, progressing to a constant beeping sound until
movement is detected.
Figure 9: Venner DruGuardian
™
loaded in cradle for below or above shelf
Lock the Venner DruGuardian
™
into the cradle, remove the key and store it
in a safe place. All devices in the same institution will be accessible with the
same key.
CAUTION: Only the nominated person for the institution should have access
to the key.
Figure 8b: Venner DruGuardian
™
and cradle if affixing above shelf
In addition to door opening and closing times the data micro SD card will record
when the alarm progressed from intermittent to constant sound. Captured
images from the camera will be stored on the image micro SD card along with a
time stamp and location cradle RFID code reading.
Contents from both micro SD cards can be uploaded onto
www.VennerDruGuardian.com
to generate a range of reports for analytical
purposes. Visit the website for detailed instructions.
Replacing the micro SD cards:
(i) Remove Venner DruGuardian
™
from the cradle. Be sure to note down the
cradle RFID code and the physical location of the cradle, in order to associate
the data downloaded from each Venner DruGuardian
™
later. This should be
stored with the nominated person/key holder.
(ii) Remove one or both micro SD cards – each card will contain the 12-digit
RFID code from the fixed cradle. If the same SD card is shared between multiple
cradles, it will contain all RFID codes from the fixed cradles according to the
sequential arrangement it had been in.
(iii) Replace the micro SD cards making sure the cards are unlocked if appropriate.
There are two ways of charging the Venner DruGuardian
™
:
1.
Using the mains charger or USB charger from your Venner DruGuardian
™
supplier:
•
Remove the Venner DruGuardian
™
from its cradle
•
Set all 8 function switches to OFF (downwards)
•
Connect the mains charger to the socket at the rear of the unit or to
the USB socket
•
After charging for 16 hours, remove the charger, and it is now ready for use
(refer to Section 2.3)
Battery and charging
3.
Figure 10: Mains charger socket
11
10
