- 3 -
1. MEASURE THE INSTALLATION AND INSTALL DUCTWORK
The minimum hood distance above cooktop must not be less than 24” for best capture of
cooking impurities.
Decide where the ductwork will run between the hood and the outside.
A straight, short duct run will allow the hood to perform most efficiently.
Long duct runs, elbows and transitions will reduce the performance of the hood. Use as
few of them as possible. Larger ducting may be required for best performance with longer
duct runs.
Install wall cap or roof cap. Connect round metal ductwork to cap and work back towards
the hood location. Use metal foil duct tape to seal the joints between ductwork sections.
WARNING
When performing installation, servicing or cleaning the unit, it is recommended to wear safety glasses and gloves.
!
WARNING
To reduce the risk of fire, use only metal ductwork.
6
”
ROUND DUCT
ROOF CAP
ROUND
ELBOW
24
”
ABOVE
COOKING
S
URFACE
WALL CAP
HOOD
DECORATIVE
FLUE
HH0094A
2. PREPARE THE INSTALLATION
Make sure that the following items are included:
1 - Hood
1 - Hood Glass Panel
1 - Decorative Flue Assembly (lower and upper flues)
1 - Metal Air Outlet
1 - Hood Mounting Bracket
1 - Upper Flue Mounting Bracket
1 - Parts Bag containing:
7 - No. 8 x 1¼” Flat Head Screws
9 - Drywall Anchors
2 - No. 8 x 1¼” Screws
2 - Washers
6 - No. 8 x 5/16” Screws
4 - Hood Glass Panel Special Flat Head Screws
4 - Hood Glass Panel Rubber Spacers
1 - Aluminum Grease Filter
1 - Installation Manual
HR0022
UPPER
DECORATIVE FLUE
HOOD
MOUNTING BRACKET
UPPER FLUE
MOUNTING BRACKET
LOWER
DECORATIVE FLUE
METAL
AIR OUTLET
!
NOTE: Before proceeding to the installation, check the contents of the box. If items are missing or damaged, contact the manufacturer.
