Venmar BROAN Elite E12000 Series, User Manual

Page: 7 / 36

- 7 -
INSTALLATION
The hood must be installed inside a
cabinet.
ATTENTION: 2 persons are required for
proper installation; the unit should be
installed by a qualifi ed operator.
For the cabinet measurements, refer
to Figure 4.
Installation directly to cabinet
Refer to Figure 5.
1. Make the 4 necessary mounting holes
in the cabinet and cut the air venting
and power cord holes.
2. Move the hood close to the bottom
of the cabinet and then secure the unit
by means of the 4 self-tapping screws
(4.2 x 32 mm) supplied.
Installation to the cabinet with bra-
ckets
Refer to Figure 6.
1. Take the two brackets out of the
accessory bag together with the 4
screws provided (4.2 x 15 mm).
2. Fit the brackets (S) to the cabinet
being careful to position these
correctly.
3. Adjust the angle of the hood with
the 4 leveling screws (3.9 x 9.5 mm)
4. Fasten the hood to the brackets
using the 2 screws (M4 x 8 mm)
and 2 washers.
FIGURE 5
10-1/4”
FIGURE 4
12-3/16”
MOUNTING
SCREWS
(4.2 x 32 mm)
3-1/8”
24” - 30”
MOUNTING SCREWS
(4.2
X
15
MM
)
MOUNTING
SCREWS (M4
X
8
MM
)
FIGURE 6
8-9/16”
12”
MIN.
7-1/2”
S
LEVELING SCREWS
(3.9
X
9.5
MM
)
12-3/16”
2-3/16”
24”
30”
18-1/8” (24”)
24-1/8” (30”)
1-3/4” x 1-3/4”