Veneto VT-ANG30, User Manual, Page: 29 / 30

29
MAINTENANCE
WARNING
Before servicing or cleaning unit, switch power off at service panel and lock in access to prevent it being switched on accidentally.
If the power panel can not be locked, put a prominent warning device, such as a brightly coloured label.
Grease filters
The grease filters should be cleaned once a month or as needed. To remove grease filter, pull the metal latch down. This will disengage the filter
hood. Tilt the filter down, then remove. To clean the filters, use a solution of warm water and detergent. Let them dry, then reinstall. The metal
filters are dishwasher-safe. Clean filters made entirely of metal in the dishwasher using a non-phosphate detergent. Using a detergent containing
phosphates and local water conditions may cause discoloration of the filters, without affecting their performance. This discoloration is not covered
under warranty.
Hood Cleaning
Cleaning stainless steel: how to keep his "lustrous appearance" and help prevent corrosion.
What to do:
- Wash surfaces regularly with a cloth or a clean cloth soaked in warm water and mild soap or dish detergent.
- Always clean in the direction of squall lines (direction of the grain).
- Always rinse well with clear water (2 or 3 times) after cleaning and dry completely.
- A household cleaner designed for stainless steel can also be used.
Don'ts:
- Use steel wool or stainless steel or any other scrapers to remove stubborn dirt.
- Use any harsh or abrasive cleansers.
- Allow dirt to accumulate.
- Allow the plaster dust or any other construction residues reach the hood. Cover the hood while working to ensure no dust hood.
To avoid when choosing a detergent
- Any cleaners that contain bleach, because they attack stainless steel.
- Any product containing chloride, fluoride, iodide, bromide, they quickly deteriorate surfaces.
- Any combustible products used for cleaning such as acetone, alcohol, ether, benzene, etc.. These products are highly explosive and should
never be used near a stove.
To replace the bulbs:
1. Gently push the bulb up and turn in the opposite direction of clockwise to
disengage the drivers out of their grooves.
2. Install the new bulb by dragging its drivers in the grooves inside the socket.
3. Gently push up and turn in the clockwise until the bulb is in place.
NOTE: If necessary, use a rubber dishwashing glove to get a better grip of the bulb
when removing it.