Instructions for the installer, maintenance
technician and final user
51
© SandenVendo Europe SpA
7.8 General Cleaning Operation
To have perfect working conditions it is important that the machine is cleaned and
kept well. Please follow the below indications
Cleaning of painted
areas and removal
of small scratches
Clean the Vendor with water and soap. The exterior may be waxed
with any good automobile wax
Small internal signs of corrosion can be removed using sand paper
and covering the surface with nitrocellulose lacquer
Paint splashes and grease or glazing compounds can be removed
using solvent
Cooling area
Be sure that all vanes and tubings are clean and air passage is free
of any obstructions.
Condenser and evaporator must be kept clean in order to achieve
the full cooling performance. The condenser should be cleaned
every three months with a vacuum cleaner and brush. Make sure
that all fans and tubes are free and clean.
Caution
When working on the cooling unit: Do not touch the
evaporator heater (on outdoor machines only). Contact can cause
burns.
Product delivery
exit
Keep the product exit clean and without deposits
Cleaning of
drainage tube
Rinse condensate drain hose with clean water or clean with
compressed air. Water from the evaporator region must flow freely
into the condensate pan next to the compressor.
Trays and Lift
For easy cleaning, the trays can be removed from the machine.
To remove the dirt from the product slides (1), tray sides and
pushers use warm water with a little detergent. Dry thoroughly after
cleaning and apply a little silicone spray to the slider surface (1).
In case of broken glass bottles please make sure to remove the
pieces of broken glass and clean the affected areas thoroughly and
dry.
Caution - risk of injury. Wear protective gloves.
