All rights reserved.
Copyright 2020 Vendlet ApS
VENDLET must be used
and installed in accordance
with the manual
QUICK GUIDE
Ver
s. 1.2 - April 2020
1. Fold the slide sheet corner elastic straps around the mattress.
2. Check that the surface is smooth and even without creases and folds.
Make sure that slippery side is facing upwards.
3. Fasten the velcro tapes around the mattress frame.
It is important that the tapes are fastened around the frame
under the mattress and not around the bed frame as this will
prevent the back, thigh, and foot parts of the bed from being raised.
ATTACHING THE SLIDE SHEET
VEND
LET
V5S Speed Adjust
VEND
LET
Bari
1. Place the turning sheet in the middle of the bed, velcro tape facing
downward.
2. Press the turning sheet onto the velcro strip on one of the bars; begin at the
head of the bed and work your way down to the foot of the bed.
3. The turning sheet must always be placed OVER the bars to
prevent the fingers, hair ect. of the patient from getting caught
under the sheet.
The pulling power will be reduced and the motors will switch off when the
turning sheet is pulled in by the bar if the sheet is placed under the bars.
4. Press the or button on the hand control and allow approx. two-thirds
of the sheet to be pulled in by the bar.
5. Press the turning sheet onto the velcro strip on the opposite bar.
6. Use this bar to pull in the turning sheet by pressing the or , button
until the sheet covers the mattress evenly with the red line at the centre of the
mattress.
ATTACHING THE TURNING SHEET
Scan the QR code
to watch instruction
videos
+45 9631 0050 [email protected] www.vendlet.dk
