482929 • Fabra Hood Form C & D, Rev. 4, August 2018
Copyright 2018 © Venco Products
4
As a result of our commitment to continuous improvement, Venco reserves the right to change specifications
without notice.
Our Commitment
Phone: 1.833.881.0565 • Fax: 715.355.2399 • E-mail: [email protected] • Website: www.vencoproducts.com
Step 11
Tighten all pivot bracket fasteners.
NOTE: There may be extra fasteners.
Step 10
Assemble HOOD PANELS
to HOOD RAIL ASSEMBLY.
The HOOD END ASSEMBLY
with the MALE RIB is to be
installed first, see Figure 9,
Detail E. Place the remaining
HOOD PANELS in place,
interlocking panels as you
go; Detail E. Secure each
HOOD PANEL to the HOOD
RAIL ASSEMBLY as it is put
in place using four 12 X 3/8
inch sheet metal screws with
sealing washers per HOOD
PANEL. The HOOD END
ASSEMBLY with the FEMALE
RIB is to be installed last.
NOTE: Hoods over 9 feet
wide are supplied with
special HOOD CLIPS.
See Detail F. HOOD
PANELS have predrilled holes for HOOD CLIP
installation. Install CLIPS as HOOD PANELS are
being put in place using one 12 X 5/8 inch sheet
metal screw with sealing washer per HOOD
CLIP. To install CLIPS in the last panel, leave the
END BIRDSCREEN ASSEMBLY out to provide
access to the underside of the hood. The END
BIRDSCREEN ASSEMBLY can be easily replaced
after the hood is completely assembled.
Figure 9 Fabra hood Form C & D 471323
Step 11 Fabra hood Form C & D 471323
Figure 9
