Fabra Hood • Form C and D
2
Figure 3 Fabra hood Form C & D 471323
Step 3
Attach the HOOD SUPPORT ANGLE to the BASE ASSEMBLY (hand tight) using four 1/2-20 fasteners per angle, see
Figure 3, Detail B. On some units, two DIAGONAL BRACES come pre-attached to the HOOD SUPPORT ANGLE.
Fasten the loose end of the DIAGONAL BRACES to the BASE ASSEMBLY using one 1/4-20 fastener per diagonal
brace. See Figure 3, Detail C.
Step 4
Tighten all fasteners. Caulk all inside corners where
the base sections come together. At this point
the base may be lifted onto the roof curb before
proceeding with further assembly.
Step 5
Bolt together the SIDE BIRDSCREEN ASSEMBLY LEFT to the SIDE BIRDSCREEN ASSEMBLY RIGHT, using
two 1/4 -20 fasteners per SIDE BIRDSCREEN ASSEMBLY, see Figure 4.
Step 6
Attach the SIDE BIRDSCREEN ASSEMBLY to the HOOD SUPPORT ANGLE and BASE ASSEMBLY using
four 1/4-20 X 1 inch fasteners per screen assembly, see Figure 5.
Figure 5 Fabra hood Form C & D 471323
Figure 4 Fabra hood Form C & D 471323
Figure 4
Figure 3
Figure 5
