5
10
GAS CONNECTION - The gas inlet line size of this appliance is 3/4" NPT. For proper operation, the gas
supply service line must be the same size or greater than the inlet line size of the appliance. The gas
line size must not be reduced at any point along the supply line.
MANUAL SHUT - OFF V ALVE - A gas pressure regulator and a contractor-supplied shut-o valve must be
plumbed in the gas service line ahead of the appliance in a physical location where it can be reached
quickly in the event of an emergency .
INSTALLATION - GAS STANDARDS AND CODES
1. The appliance and its individual shut o valve must be disconnected from the gas supply piping
system during any pressure testing of that system at test pressure in excess of 1/2 psi (3.45 kPa).
2. The appliance must be isolated from the gas supply piping system by closing the individual manual
shut-o valve during any pressure testing of the gas supply piping system at test pressures equal to or
less than 1/2 PSI.
IMPORTANT - The installation of this appliance must conform to local codes or, in the absence of local
codes, with the National Fuel Gas Code ANSI Z223.1, Natural Gas Installation Code, CAN/CGA-B149-1,
or the Propane Installation Code, CAN/CGA-B149-2 as applicable, incluiding:
B
C
G
F
E
C
D
A
A. Gas pressure regulator
B. 90º Street elbow
C. Adapter (must be 3/4" male pipe thread)
D. Flexible connector
E. Manual gas shut-off valve
F. 3/4" gas supply
G. Use pipe-joint compound
H. Step down regulator
H
LP GAS
A. Gas pressure regulator
A
D
C
E
F
G
C
B
GAS
B. 90º Street elbow
C. Adapter (must be 3/4" male pipe thread)
D. Flexible connector
E. Manual gas shut-off valve
F. 3/4" gas supply
G. Use pipe-joint compound
NATURAL
GRIDDLE
GRIDDLE
1 - ASSY., GRIDDLE PLATE
2 - KNOB
3 - SCREW
4 - PANEL
TO REPAIR, TO GET ACESS, FOLLOW THE INSTRUCTIONS
1 - Lift the griddle plate assembly
2 - Take off the knobs
3 - Take off the panel fastening screws
4 - Take off the panel
Visually double check any installer-supplied intake pipes and/or blow them out using compressed air to
clear any dir t or debris, threading chips, or other foreign matter before installing a service line.
Those par ticles will clog gas ori ces when gas pressure is applied. Compounds used on threaded joints
of this appliance piping must be resistant to the action of NG and LP gas and provide a gas tight seal to
prevent leaks.
When installing the pressure regulator - remember it can only handle 1/2 PSI. In e very LPG installation, you
have high source pressures, ranging from 20 PSI to 100 PSI. If the high pressure gas line from the LPG tank is
directly connected to the unit without the proper step-down regulator, it will rupture the diaphragm in the
valve, rendering it useless.
!
WARNING
The gas pressure regulator must be installed in the gas line failure to install a pressure regulator will void
the equipment warranty. The regulators supplied with ranges have 3/4" NPT connections; the regulator is
adjusted at the factory for 4" W.C. (water column) manifold gas pressure (natural gas) or 10" W.C. manifold
gas pressure for propane gas operation.
