Velux KMX 200, Directions For Use Manual

Page: 4 / 50

6 VELUX VELUX 7
Completed
Menu
No. 1
Window
Locate
Register Back
P1
P2
Prepare products
for registration and
press Register
within 10 minutes
P1
P2
Enter
Eesti
English
Español
Français
laNguagE
auto sEt-uP
auto sEt-uP
auto sEt-uP
House
P1
P2
Initial set-up
5
Press "Register" to start registration.
6
Registration is running. This can take up to two minutes.
7
The display shows "Completed" when all products have
been registered.
Note: If the display shows "Failed", remove the batteries
from the remote control. Prepare the products for registra-
tion, see section
Resettingandpreparingforregistration .
Repeat the initial set-up .
8
The display shows one of the registered products.
Press
to see the other registered products.
For use of more than one remote control, all products must
be registered in one of the remote controls, see above.
Then the information must be copied from this remote
control to the other remote controls, see section
Using
additionalactivationcontrols.
Products to be operated with the remote control must be
registered in the remote control. Registration, however,
depends on whether the remote control is new or whether
it is already used for operating other products.
1
• If the remote control is already in operation, proceed
with section Registeringnewproducts .
• If the remote control is new, proceed as follows.
When the initial set-up has been completed, the registered
products will appear in the display.
2
Slide off the battery cover of remote control as shown.
Insert the three batteries supplied (type AA, 1.5 volt).
Replace cover.
3
Choose language:
Press
to highlight your language.
Press "Enter" to confirm your choice.
4
Prepare products for registration.
Disconnect the mains or battery supply for 1 minute and
then reconnect it. The products can now be registered in
the remote control within the next 10 minutes.