Velux INTEGRA KLR 200, User Manual

Page: 95 / 116

Setting up
Extension of your VELUX INTEGRA
®
system - Joint operation of io-homecontrol
®
products
3
Continue on the next page
VELUX INTEGRA
®
KLR 200
VELUX 95
Diode
Key button
RESET button
To operate other types of io-homecontrol ® products than
VELUX INTEGRA
®
products with control pad KLR 200 or
operate your VELUX INTEGRA ® products with another type of
io-homecontrol ® control than control pad KLR 200, all products
must have the same security key.
Please refer to the lists with reference pages in the section
Exten-
sion of your VELUX INTEGRA
®
system
to see how control pad
KLR 200 can be combined with other specifically described types
of io-homecontrol
® products and systems using the same radio
frequency when communicating. Below you can see how to con-
figure io-homecontrol
® products in general to include them in joint
systems and how to create a new security key. In principle, control
pad KLR 200 is combinable with other controls without any need
for further instructions but please be aware that not all controls
offer joint operation of io-homecontrol
® products.
Under the lid on the back of the control pad KLR 200, a
key
button
can be activated by pressing it with a pointed object.
Depending on whether you want to
receive
,
send
or
create
a new
security key, you must press this key button for a certain period of
time.
Receive
the security key of another control:
Press the key button briefly (max 2 seconds) until the diode starts
flashing slowly
(1 flash per sec).
Send
the security key to another control:
Press the key button a little longer (2-7 seconds) until the diode
starts flashing a little faster
(3 flashes per sec).
Create
a new security key:
Press the key button for a long time (7-15 seconds) until the diode
starts flashing very fast
(7 flashes per sec).
IMPORTANT:
Prior to creating a new security key, you must check
that all products in the control pad are operable. If a product is not
operable, this product will not be operable with a new security key
either.
To
cancel
receiving, sending or creating a security key, you must
press and hold the key button until the diode goes out.
The instructions on the following pages show how to transfer the
security key depending on which of the three situations is relevant.