Setting up
Extension of your VELUX INTEGRA
®
system - Adding a control
3
RESET
P1
P2
Enter
Dansk
English
Français
Deutsch
LANGUAGE
11
:
0 0
P1
P2
Enter
Back
SET TIME
A
B
B
B
B
2
3
1
Continue on the next page
VELUX INTEGRA
®
KLR 200
VELUX 44
Adding a VELUX INTEGRA
®
controller KRX 100 to your system
already operated with a control pad KLR 200
The instructions below show how to copy the contents of control
pad KLR 200 to controller KRX 100. See also the instructions for
the controller.
Note:
Only available for VELUX INTEGRA
®
products with radio
frequency 868 MHz.
Control pad KLR 200 to
send
a copy is called control
A
.
Controller KRX 100 to
receive
a copy is called control
B
.
First execute items 1-3 with
B
.
Connect to mains supply:
Remove the back cover of the controller as shown. Click the adap-
tor plug into the controller and replace the cover. Connect the
adaptor to mains supply.
Note:
The controller saves the selected settings even if the mains
supply is disconnected. Therefore, it is advisable not to fit the
controller permanently until the sunscreening products and the
sensors have been registered in the controller.
However, time and date are only saved for 30 seconds after dis-
connection of mains supply.
Select language:
Press
to highlight your
language.
Press
"Enter" to confirm
your choice.
Set time:
Press
to set minutes.
Press
"Enter" to change to
hours.
Press
to set hours.
Press
"Enter" to confirm
your settings.