- 5 -
STOVES & CHIMNEYS
NOTICE FOR SAFETY
CAUTION
In case of storing this heater, be sure that you store
it in the dry places indoor instead of hot and humid
environment.
(Otherwise, it gets rusty or goes into trouble)
If the supply cord is damaged, it must be replaced by
the manufacturer or its service agent or simi-larly
qualifi ed person in order to avoid a hazard.
Do not put this heater on unstable surface of ground
such as inclined or bumpy.
(The heater may not work properly.)
Do not put an excessive physical shock to the re-
mote controller, nor disassemble it arbitrarily.
(it arbitrarily.)
You must take out the plug from the outlet, if there
is a fl ash of lightening or thunder or you don’t use it
for a long time.
(Otherwise, it is exposed to the danger of electrical
shock, short circuit or a fi re.)
Call your local after sales service agent in case the
power cord is damaged.
(Otherwise, it is exposed to the danger of electrical
shock, short circuit or a fi re.)
Do not shower water to the heater directly, nor use
benzene, thinner, alcohol for cleaning.
(Otherwise, it is exposed to the danger of electrical
shock, short circuit or a fi re.)
Do not operate this heater in the place where it gets
wet by the humid such as bathroom.
(It may cause an electrical short circuit or an electrical
shock accident)
TIPS BEFORE INSTALLATION ...
1. Make sure the safety in the place where you wish to use this heater.
* The ground surface and surrounding should be plain and non-flammable, and solid.
* You need to have sufficient space surrounding the heater at least 15cm from the wall and the left & right side, at least 1 m distance from the ceiling and the
front side without any obstacle.
* You need to use exhaust duct in case of operating in small spaces. It is recommended but not required. Take a look at the drawing.
(Recommended Duct specification: 75mm (Diameter) x 5meter long-aluminum duct) (Be sure there must not be rain drops into the exhaust duct end.) (You
must ventilate frequently with fresh air by opening window or fan.)
* You must put an extinguisher beside the heater.
* There must not be direct sun light, excessive heat near the heater.
* After you fix the installation, lock the caster for avoiding unexpected movement.
* Do not use this heater near fabric curtain, carpet or plastic or vinyl curtain which may cover the heater in case of falling down by the wind or by any physical
force, which may cause a fire.
* The heater must not be located immediately below a socket-outlet.
* Positioned so that the plug is accessible.
2. You must use Diesel or kerosene as fuel.
* If you use other fuel, it may cause an excessive soot or trouble of malfunction.
* In case of refueling make sure the heater is turned OFF.
* To be made by the manufacturer or his service agent who should be contacted if there is an oil leakage.
* Regulations concerning the disposal of oil when scrapping the appliance have to be followed.
3. The proper electricity is 220/230V, 50Hz. It will be applied and adjusted as per customer’s request.
You must supply power as per its requirement only once it is adjusted.
How to install the product
* Install the heater in the flat area. If you install the heater in sloped area, combustion furnace
may be damaged by the irregular combustion.
* Install the flue tube for the indoor use. If the flue tube passes through the inflammable
wall, wrap the inside wall more than 3cm with nonflammable insulation.
* Use stainless steel tube (75mm diameter) for the flue tube. Length of tube must be shorter
than 4m and number of bent must not exceed 2.
* If the bent number of flue tube is more than 2 or when the length of tube is longer than 4m,
it may cause incomplete combustion.
