12
13
FIG.P
SET+MODE
2S
MODE for changing
from low to high
MODE for changing
from hour to minute
KM/H
MODE
MODE
MODE
MODE
KM/H
2074
KM/H
SPD
KM/H
KM/H
Set speed unit
Set circumference
12Hr/24Hr
Set clock
Note:
HOW TO USE THE BICYCLE COMPUTER
1. To enter into Set up mode, replace the battery or press
SET and MODE together for 3 seconds. The display will
return to show KM/H flashing as the first setting to change
2. Press and hold SET to switch between "KM/H" and "M/H".
Press MODE to confirm your choice and exit. Then proceed
to the bike wheel circumference setting.
3."2074" will display and the last figure "4" will flash, press
SET to select value and press MODE to confirm and exit.
Then proceed to next figure setting, repeat for the 4 units.
After finish all figure settings, press MODE to confirm and
proceed to CLOCK setting. Press SET to select value and
press MODE to confirm and proceed to next. (FIG.P)
Setting the Speed unit, Wheel circumference
and Clock.
The bike circumference unit is mm.
When in 12H format, PM is displayed
for afternoon.
When the computer has been installed and the wheel
size has been programmed into the computer, you are
ready to use the cycle computer:
1.Reset previous values to zero before each measurement.
When the speed is zero (except SCAN mode), hold SET for
2 seconds to reset the value of DST(distance), RTM (riding time),
AVS (average speed), RES (relative speed) and MXS(max. speed)
2.The measurement begins once riding on the bicycle. If
the computer receives no signal during riding, the " " in the
display will not flash. Stop riding and check if the magnet
is positioned correctly.
3.Press MODE to select the preferred display or select the
SCAN mode. When in SCAN mode the display will
change between all functions every 4 seconds.
4.The computer will turn off automatically if there is
no operation or signal for 8 minutes, the data for the
jouney will be saved. You can press any button to
turn on the computer to receive the signal again.
