24
.
w w w . v e l o d y n e . c o m
Digital Drive User’s Manual
AND REMEMBER: Use the UP, DOWN, RIGHT and LEFT directional arrow buttons that surround
SELECT to move through the fields of the setup screen, and change settings by using the
SELECT button, then the UP and DOWN arrow keys. Or, you can skip the SELECT button and
change values using the SET +/- buttons.
14. When setting the low pass crossover, begin by setting the frequency and slope to the same
values as the crossover settings on your receiver/processor (for example, many units have
a large/small satellite setting). Again, consult your receiver/processor owner’s manual for
more information. You will notice that changing these values “cascades” the values out to
all the presets. That is because once these values are set, they will not normally change
from preset to preset, but if later you wish to customize a specific preset you can. An
example of a crossover changed to 100Hz is shown below:
