Int erconnect Cables
7
.
w w w . v e l o d y n e . c o m
CHT-R User’s Manual
When installing your new Velodyne subwoofer using the line-level connections, you should always
use shielded phono cables. There are many decent cables available today, most any of which
will work perfectly well. We do recommend that you keep the length of cable as short as
possible to avoid any potential noise problems.
When using speaker level connections, use a quality speaker cable that mates well with the
connectors (at least 14-gauge). Be very careful to avoid any loose or frayed strands that could
result in a short, causing a dangerous condition and possible damage to your unit. Cables of
extremely large size are typically not required. Extremely large gauge wire may not properly fit
in the binding posts, resulting in a poor connection and possible short circuits.
Placement
True subwoofers operate at extremely low frequencies, which are primarily omni-directional.
While it is recommended that the subwoofers be placed on the same plane as the satellite
speakers, room and system conditions often dictate otherwise. Keep in mind that frequency
response and output level can be drastically influenced by placement, depending on the acoustic
properties of your listening room. Typically, the optimum location for a subwoofer is in a front
corner of your listening room. This location will usually offer the greatest output levels and
optimum low frequency extension. The worst location for a subwoofer is typically far away from
any walls, close to the center of your room and near an opening or door way. Avoid these
locations when possible. When using a pair of Velodyne subwoofers in stereo, it is preferable
to place each subwoofer near the satellite of the same channel. Typically, a minimum distance
of one to two feet from your TV to the subwoofer will be adequate to avoid any
magnetic interference.
Caution!
This subwoofer has electronics built into the cabinet. Do not place the cabinet next to
sources of heat such as furnace registers, radiators, etc. Do not place the unit near
sources of excessive moisture, such as evaporative coolers, humidifiers, etc. The power
cord should be routed in such a way that it will not be walked on, pinched, or
compressed in any way that could result in damaging the insulation or wire.
