www.velocitydetection.com Doc: GLT-294-7-5 Issue: 001 Date: 05/03/2020
Power on Procedure
1.
After the above has been completed, turn the panel on (Via AC Only). The panel will follow the same power up
sequence described in initial power up section above
2.
The panel will now display one of the following messages
Message
Meaning
Panel has not detected any
modules fitted during its power
up check.
Power down the panel and check
that the expected modules are
fitted, and that all module cables
are correctly inserted.
Note that the panel will need at
least one module fitted to run.
The panel has detected a new
module added to a port that was
previously empty.
This is the usual message seen
the first time a panel is
configured
The panel has detected a
different type of module fitted to
a port that was previously
occupied.
The panel has detected a module
fitted to a port that is the same
type, but it`s serial number has
changed.
This could happen if a loop
module was swapped with
another one, for example.
The panel has detected no
module fitted to a port that was
previously occupied.