22
Problems with the FreeWave Viewer can
usually be traced to the following most
common causes. Perform the following
steps to diagnose and correct the
problem:
Make sure that your batteries are charged
and inserted into your device correctly.
Check that the Sync and AV cables are in
good condition and properly connected.
Make sure that the Receiver is powered
on and at the correct setting.
Make sure that the Receiver and
Transmitter are on the same channel
When using the FreeWave Viewer’s
shutter release function, your camera may
not be able to release the shutter if the
lens is set to Auto Focus and focus cannot
be achieved on subject. Switch your
camera to Manual Focus to ensure proper
shutter release.
If the receiver freezes up, turn it off and
on again to restore normal function
If the camera is having difficulty focusing,
try any of the following solutions:
a. Select a single point of focus in the
camera.
b. Use the camera in Manual Focus, if
applicable.
c. Switch the Receiver unit to Continuous
mode. Press the Shutter/Auto Focus
button once to start the camera’s Auto
Focus. This will continuously send a
signal to the camera until the camera
focuses and fires. Once the camera
fires, press the Shutter/Auto Focus
again to terminate the signal.
TROUBLESHOOTING