12
1.
Turn on the Transmitter by sliding
the power switch upward. When
Transmitter power is on, the Power
LED Indicator shines red.
Note: If battery power for the Transmitter is
low, the Transmitter’s Power LED Indicator
will flash red. This means that the batteries
should be replaced or recharged immediately.
SYNCHRONIZING TRANSMITTER AND RECEIVER
2.
Turn on the Receiver by sliding the
power switch upward. The Receiver
will show the FreeWave Viewer
start-up screen graphic and then seek
out a signal.
Note: If battery power for the Receiver is low,
the Receiver’s Power LED Indicator will flash
red and an icon of a battery will flash on the
LCD screen. This means that the batteries
should be replaced or recharged immediately.
3.
If no signal is found, “Disconnected”
will display at the bottom of the screen.
Make sure the Transmitter is on and
that the Transmitter and Receiver are
set to the same channel – the switch on
the top of the Transmitter should be
set to the same number as the number
shown at the top left corner of the
Receiver’s LCD screen.