Velleman PEREL EDP1, User Manual

Page: 7 / 78

EDP1/EDPTW
V. 04 – 23/04/2019 6 ©Velleman nv
4. Battery
Refer to the illustrations on page 2 of this manual.
1. Open the transmitter to reveal the battery compartment. Use a
flat-head screwdriver.
2. Install the CR2032 battery according to the correct polarity.
3. Close the battery compartment. Proceed with the installation.
Remark: Remove the batteries if the transmitter will not be used for
a longer period.
CAUTION:
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
Batteries (battery pack or batteries installed) shall not be
exposed to excessive heat such as sunshine, fire or the like.
Do not puncture batteries or throw them in fire as they may
explode. Do not attempt to recharge non-rechargeable
batteries (alkaline). Dispose of batteries in accordance with
local regulations. Keep batteries away from children.
5. Installation
Test the operating range between the receiver and the
transmitter. The operating range is 150 m in the open air,
but may be less due to walls and other obstructions such as
PVC or metal frames.
Refer to the illustrations on page 2 of this manual.
1. Carefully open the housing of the transmitter and use the back
plate as a template. Mark the drilling holes at the required
height.
2. Drill the holes using a drill and the appropriate drill bit (not
included).
3. Insert a nylon plug (included) into each hole.
4. Fix the back plate with the included screws. Click the front plate
onto the back plate.
5. Simply plug the receiver into the mains.
Remark: You can also fix the transmitter using double-sided tape.