CAMSETW5
VELLEMAN
2
5. Description Receiver
1. power switch
2. antenna socket
3. power socket
4. A/V output
5. antenna
6. channel button
7. channel indicator
6. Installation
1.
Put the camera in the desired location and then adjust the angle.
2.
Connect the adapter (DC 8V 200mA) to the camera.
3.
Connect the antenna to the receiver.
4.
Connect the adapter (DC 8V 200mA) to the receiver. Slide the power switch to the
ON
position.
5.
Connect the receiver to a monitor/TV with the A/V cable (yellow for video and red for audio).
6.
Switch on the monitor/TV and select A/V
mode.
7. Use the channel button to s
et the same channel on the receiver as on the camera .The camera picture is now
displayed on the monitor/TV.
8.
Adjust the brightness, contrast and colour of the monitor/TV.
7. Camera Channel Set-up
Remove the camera cover and reach for the DIP switches next to the lens. Choose a channel by setting the DIP
switches. Replace the camera cover. Use the SEL button to select the same channel for the receiver as for the
camera. The image is now displayed on the TV.
8. General Guidelines
•
Protect the device against water and don't put objects containing water (e.g. vases) on top of the device
•
Turn off the camera/receiver if the system is not in use.
•
Use the adapter to connect /disconnect the device with/from the mains.
•
Do not cut off the DC power cable to try and use it with a different power source
9. Specifications
Operating temperature
0 to +50°C/ +32 to +122°F
Storage temperature
-30
to +80°C/ -22 to +176°F
Operating humidity
85% RH
Camera
Imaging sensor
CMOS
Total pixels
628 x 582 (PAL); 510 x 492 (NTSC)
Viewing angle
62°
Transmission frequency
2.400 to 2.483MHz
Transmission power
10mW/CE; 2mW/FCC
Modulation type
FM
Bandwidth
18MHz
Power supply
8V DC
Current Consumption
80mA & 120mA (IR ON)
Effective range (line of sight)
100m
Dimensions (W x D x H)
Ø 44 x 56mm (without bracket)
Weight
220g
