CAMSET26
29/09/2010
©Velleman
nv
4
•
Make sure the vehicles’ engine is off and power is removed from the electrical
system. Disconnect the battery and remove the ignition key from the ignition
switch.
•
Mount the LCD
[A]
with the mounting bracket
[B]
on the dashboard using the
double sided tape on the bottom of the bracket. Make sure the driver has a
clear view on the monitor.
•
Connect the monitor cable
[D]
to the monitor. The connector fits in only one
way, do not force.
•
Guide the video cable
[C]
to the back of the car where the camera will be
mounted.
•
Mount the camera in the desired location on the back of a truck, camper, all-
terrain vehicle… (mounting accessories not included).
•
Drill a hole (Ø20mm) in the coachwork (drill not included).
•
Insert the cables
[5, 6]
of the camera
[F]
into the hole. Place the rubber
sealing ring inside the hole to prevent water from entering the vehicle.
•
Connect the video cable
[C]
to the camera
[5, yellow]
; connect the other end
to the monitor cable
[D2, yellow]
.
•
Connect the red wire
[3]
of the monitor cable
[D]
to the cars +12V electrical
circuit, at a location where there is only power once the ignition key is turned
(run circuit).
•
Connect the black wire
[4]
of the monitor cable
[D]
to ground (GND).
•
Connect the red wire
[3]
of power cable
[E]
to the reverse light circuit (+12V).
•
Connect the black wire
[4]
of power cable
[E]
to ground (GND).
•
Connect the other end of power cable
[E]
to the camera
[6, black]
.
•
Restore power to the vehicles’ electrical system; insert the ignition key in the
ignition switch and turn.
•
The monitor will now show the image of the camera.
6.
Technical specifications
system NTSC
monitor size
3.5"
TFT
number of pixels
480(H) x 320(V)
video inputs
1
camera
pick-up element
1/4" colour CMOS
synchronization internal
video output
mirror image
horizontal resolution
420 TV-lines
IR LEDs
8
min. illumination
0 Lux when IR on
lens angle
120°
S/N ratio
>= 48dB
video input signal
1.0Vpp composite video signal at 75 ohm
A/V input connections
RCA connector
power supply
DC 12V ±1.5V
max. current
300mA
cable
1x monitor cable (±2m), 1x power cable (±1.5m), 1x
video cable (±6m), 1x camera cable (±1.5m)
operating temperature
-20°C ~ +60°C
dimensions
monitor
93 x 102 x 45mm
camera
75 x 75 x 68mm