CAMIP5
Rev.01
27.10.2010
©
Velleman nv
10
•
When entering an administrator password, the user can open the
For Operator
layout.
•
In this layout, it is possible to pan/tilt the camera using the control panel:
Press on the arrows around the blue button to move in that
direction.
Press and hold to move faster.
Press in the centre to start auto-scanning the whole area.
auto tilt (vertical movement)
stop auto tilt
auto pan (horizontal movement)
stop auto pan
make alarm output
[11.1]
active.
deactivate alarm output
Note:
when the camera is in auto tilt/auto pan mode, motion detection and external alarm input are
disabled!
•
Check the
Flip
checkbox in case the image is shown upside down.
•
Check the
Mirror
checkbox to mirror the image.
•
Set the resolution to 320*240 or 640*480.
•
Set the mode to 50Hz or 60Hz.
Note:
the camera is not suitable for outdoor use! The outdoor setting could be used in case the
camera is pointed towards a bright natural light source.
•
Set the brightness and contrast of the image with the “+” and “-” buttons.
For Administrator
layout
•
The
For Administrator
layout is only available when logged in with an administrator account. It
is used for advanced configuration of the cameras.
Notes:
•
Select the desired camera before opening the
For Administrator
layout.
•
Depending on the ticked checkboxes, different data entry fields are shown. Hence the
display you see for a certain option might differ from the images used below.
Device info
•
Device ID, firmware version and Web User Interface version are shown (see image above).