CAMCOLD24 - CAMCOLD24W
V. 02 – 30/05/2013
12
©Velleman nv
AUTO
The camera switches from day to night and the other way
round along with the amount of light through the lens. The
camera makes colour images during the day and black and
white images during the night. The following extra settings
are used:
BURST
: you can switch burst on or off to improve the
image quality. The burst function sends a colour signal to
the monitor in B/W mode. This may degrade the clarity
of the image.
DELAY CNT
: delay counter. Defines the delay before the
camera switches from day to night mode or vice versa.
This prevents the camera from switching over too quickly
if the light conditions change only briefly.
DAY
NIGHT
: sets the threshold for switching from day
to night mode. The lower the setting, the less light is
required to switch to night mode. Recommended settings
are 40-75 for indoors, and 150 for outdoors.
NIGHT
DAY
: sets the threshold for switching from
night to day mode. The higher the setting, the more light
is required to switch to day mode. Recommended
settings are 50-85 for indoors, and 175 for outdoors.
Remarks
:
The
DAY
NIGHT
setting must always be lower than the
NIGHT
DAY
setting.
Make sure that the difference between the two settings is
large enough. If the settings are too close together, the
camera will switch too often between the two modes.
Note:
The AUTO setting should only be used for a camera
not equipped with IR LEDs.
7.10
Noise reduction
Use this function to set the noise reduction mode.
Display:
2DNR
OFF
Noise reduction is switched off.
Y
Use only luminance noise reduction (
Y level
).
C
Use only colour noise reduction (
C level
).
Y/C
Use both luminance and colour noise reduction (recommended
setting). Set
Y LEVEL
for luminance and
C LEVEL
for colour
noise reduction.
