
3DPEN2
V. 02 – 09/05/2016
6
©Velleman nv
Notes:
•
Do not touch the nozzle when the pen is switched on!
•
The pen will switch to stand-by after 2 minutes of inactivity.
Repeat step 2 above to reheat the pen.
•
Preheating time depends from the set temperature (adjust
through the temperature controller
[4, 5]
) and the ambient
temperature. Make sure the set temperature is correct:
o
too hot: filament will be too hot and watery
o
too cold: filament will not melt
•
Cut off the end of the filament before inserting it through the
wire-feeding hole
[2]
.
•
Always unload the filament and clean the inside of the nozzle
[9]
after each use (see step 6 above).
7.
Troubleshooting
•
The power LED does not light.
o
The power adapter is defective. Replace the power adapter.
o
The pen is defective. Please contact your dealer.
•
The filament is not extruded from the nozzle.
o
The nozzle is blocked. Replace the nozzle.
o
The temperature is not high enough. Increase the temperature.
o
The filament fails to load. Unload the filament, cut clean and
reload.
•
The pen does not warm up.
o
The pen is defective. Please contact your dealer.
8.
Cleaning and Maintenance
•
This pen does not need any particular maintenance.
•
Occasionally wipe with a damp cloth to keep it looking new. Do
not use harsh chemicals, cleaning solvents or strong detergents to
clean the detector.