3DPEN2
V. 02 – 09/05/2016
5
©Velleman nv
4.
Features
•
can be driven by power bank, connection to AC/DC adapter not
needed
•
double click loading/unloading button to fill and remove filament
automatically
•
OLED screen, which can display company information,
temperature, speed and material
•
OSD language: multi-language customized
•
super slim design
5.
Overview
Refer to the illustrations on page 2 of this manual.
1
power input
6
wire-unloading button
2
wire-feeding hole
7
speed controller
3
OLED display
8
wire-feeding button
4
temperature
9
heating nozzle
5
temperature
6.
Operation
1.
Insert the power plug from the adapter into the power input
[1]
.
Connect the adapter to the mains. The OLED display
[3]
will
light; the pen is in standby mode.
2.
Press the wire-feeding button
[8]
once. The OLED display
[3]
will display the temperature to indicate the pen is preheating.
3.
Leave the pen to preheat for about 1 minute or until the OLED
display
[3]
displays the desired temperature.
4.
Insert the filament through the wire-feeding hole
[2]
and hold
the wire-feeding button
[8]
pressed to load it into the pen. Wait
for molten filament to come out of the nozzle
[9]
.
5.
The pen is now ready for use. Adjust the feeding speed with the
speed controller
[7]
if necessary.
6.
When done drawing, hold the wire-unloading button
[6]
pressed
to unload the filament out of the pen. Next, hold the wire-
feeding button
[8]
pressed to extrude molten filament rests and
to clean the inside of the nozzle
[9]
. Disconnect the pen from
the mains and leave it to cool down before storing.
