16
Configuration and setting
Filters cloning
NOTE
Cloning begins automatically after the
following steps.
1)
Connect two equipments using a coaxial cable in
the Test 1 output of each equipment (see position
(15) in the illustration in the General Description.
2)
On the equipment receiving the information:
locate and select MASTER OFF, SLAVE ON.
3)
On the equipment sending the information:
locate and select MASTER ON, SLAVE OFF..
NOTE
The time waited for cloning to be run (steep
2 to 3) is 11 seconds. Where cloning cannot
be started, the equipment returns to the
higher menu.
Equipment locking
NOTE
The lock is enabled when the equipment is
re-connected.
1)
Enter a sequence of 4 digits (LOCK, 0000).
2)
Locate and select LOCK, ON.
NOTE
To unlock the equipment, enter and select
the 4-digit sequence on the start screen. To
cancel equipment locking, locate and select
LOCK, OFF. If you forget the 4-digit sequence
see: Troubleshooting
.
