1a
1a
1b
1b
3a
3b
2
1a
1a
1a
1a
3a
3b
2
6
6
5
7
7
8
1
4
2
3b
3a
1b
7
1.6.3. BACKREST
1. Bring the wire (1) up through the hole (2) at the base of the backrest until fixed in place.
Note
: rubber ring
(3a) must be pushed totally in place in the mounting (3b)!
2. The wire (4) is attached to the anchor (5) on the wooden frame.
3. The two holes (7) on the backrest is hinged on the metal bracket (6)
Note:
be carefull not to pull the wire
that connects the backrest and the wooden frame.
4. Push the backrest (8) down so the backrest slips into place.
Note:
once the backrest has been mounted, test the back angle. If the backrest shifts against the wooden
frame, the length compensation is working as intended and the backrest pillow has been mounted correctly.
When removing pillows, follow the instructions in reverse!
1.6.2. SEAT
1. Place seat pillow (1a) against the metal frame (1b).
2. Ensure that the metal frame catches the hold on the seat plate so that the seat
(2)
does not move.
3. Click the cover (3a) onto the seat pillow (3b) to mount correctly.
Note:
there are buttons on both sides of the cover facing the backrest and footrest.
1.6.1. FOOTREST
1. Push the pillow against the footrest so the holes (1a) are pressed into the rubber brackets (1b).
2. Push the pillow firmly in place so that it cannot be moved up or down.
3. Click the cover (3a) onto the seat pillow (3b) to mount correctly.
Note
: there are buttons on both sides of the cover.
1.6. PLACING/REMOVING PILLOWS
