ENGLISH
145
english
After installing the machine, the installer is required to fill in the "Installation Form" that goes
with the machine.
On this form must be met the hygiene and safety requirements in force on the installation site
and must be reported any notes relating to changes or interventions necessary for the proper
functioning of the equipment.
Filled copies of the Installation form must be kept by the user and by the installer until the end
of life of the machine.
In case of withdrawal of the machine, the installer must also provide for the withdrawal of the
user's Installation form.
i
Hydraulic connections
The installer must carry out the hydraulic connections in accordance with the hygiene norms and the
hydraulic safety norms for environmental protection in force in the place of installation.
Installation report
When installation is complete, the appliance has to be started, brought to the nominal working condition
and left for 30 minutes in the "ready to operate" condition.
Afterwards, the appliance has to be turned off and emptied of the first water introduced in the whole
hydraulic circuit, to eliminate possible initial impurities.
Then the appliance must be once again loaded and brought to the nominal working conditions.
After having reached the "ready to operate" condition, the following deliveries have to be performed:
for each coffee unit, carry out a continuous delivery, in order to release at least 0.5 liters of the coffee
circuit. In the case of several dispensing points matched with the same exchanger/coffee boiler, divide the
volume on the base of the number of the dispensing points;
release the whole volume of hot water inside the boiler (3 liters for 1GR, 6 liters for 2GR, 8 liters for
3GR, 11 liters for 4GR), by performing a continuous delivery from the appropriate nozzle. In the case
of several dispensing points, divide the volume on the base of the number of the dispensing points;
Continuously release steam for at least 1 minute for each steam dispensing point;
Maintenance and repairs
After ta maintenance and/or repair intervention, the components used must ensure that the hygiene
and safety requirements initially foreseen for the appliance are still met. These are met by using original
spare parts only.
After a repair or a substitution of components related to parts in direct contact with water and food, a
washing procedure has to be carried out, as in the case of first installation.
Water renewal
In case of breaks longer than 1 week, it is necessary to perform the changing of the 100% of the water
contained in the hydraulic circuits of the machine, by using the appropriate dispensing points, as described
in the Par. "Installation report".
Summary of Contents for EMA
Page 1: ...instruction manual for user ENGLISH VELA EPU EVD DISPLAY ELEGANCE EMA...
Page 6: ...146 english...
Page 12: ......
Page 18: ......