Vela Blues 300, User Manual

Page: 15 / 24

15 10
1.2.5. SEAT DEPTH
The seat depth can be adjusted by shifting the back rest backwards
or forwards in the two C-tracks:
Loosen the two screws on both sides from the back rest hinge and
release the sliding lever for the back angle.
After this, the back rest can be shifted forwards or backwards.
IMPORTANT!
Make sure all the bolts are tightened after adjustment.
1.2.6. ELECTRIC TILT / SEAT ANGLE
Depending on the wheelchair’s equipment, the following are
selected: Fixed seat angle or electric seat angle.
Fixed seat angle can be adapted by adjusting the brace supporting
plate. (Call a service technician).
Electrical seat angling is operated from the switch (normally placed
on the same side as the control box or in the control box on VR2
and R-Net).
1.4. FOOT SUPPORTS
1.4.1. HINGED FOOTPLATES
VELA Blues 300 is fitted with two solid footplates. The footplate
is fixed on the under carriage and can be flipped up when it is not
used.
1.4.2. SWIVEL E-FOOT SUPPORTS (OPTIONAL)
Suspended on the seat frame, VELA Blues 300 can be fitted with a
set of adjustable foot supports.
The swinging out of the foot support for getting on and off occurs
by lifting the brace approx. 3 cm up and simultaneously swinging
the foot support round to the side.
The depth of the foot support is positioned with tools by adjusting the
sliding head in the seat frame backwards or forwards.
The foot support is adjusted to the leg length by adjusting the
length of the tube in the row of holes. The angle of the foot can be
adjusted with a tool in the foot plate’s pivot joint.
1.4.3. ELECTRIC ELEVATING W-LEG SUPPORT (OPTIONAL)
This type of leg support is electronically elevated up to an almost
horizontal position. Operating occurs from the tilt switch or also
from the control box (if one has optioned for a R-Net control box).
The leg support are operated individually. Swinging out the leg
support for getting on and off occurs by pressing in the locking
pawl and at the same time open the leg support by swinging it
around to the side.
The leg support can now be lifted off or it can stand open during
getting on or off. The depth of the foot support is positioned by
adjusting the hinge forwards or backwards in the seat’s C-track.
The leg length is adapted with a tool by adjusting the length tube
which is fixed in place with a bolt. The angle of the foot can be
adjusted with a tool in the foot plate’s pivot joint.
1.4.4. HEEL STOPS
It is possible to fit heel stops to the footrest