
UNISET Bügelplätze / UNISET Ironing Tables
VEIT BC 4235, 4255, 4435, 4455
5 Störungen und Beseitigung / Troubleshooting
Störung
Ursache
Abhilfe
Schlechte Absaugung bzw.
Verschmutzter Bezug
Bezug reinigen bzw. erneuern
Blaswirkung
Bei 400 V Version: Schlechte
Gebläse läuft in falscher Richtung
Gerätestecker öffnen, Phasen L1 und L3 vertauschen
Absaugung bzw. Blaswirkung
Keine Absaugung bzw.
Gebläsemotor läuft nicht
1. Thermoschutz im Motor hat durch Überlastung
Blaswirkung
ausgeschaltet; nach Abkühlung (ca. 15 Min.) wieder
betriebsbereit
2. Fußschalter prüfen
3. E-Box lösen, Schütz auf Platine prüfen
Gebläsemotor läuft laut
Lüfterrad verschmutzt und daher
Unwucht
Lüfterrad reinigen
(siehe Kap. Wartung und Pflege)
Problem
Cause
Solution
Insufficient suction or blowing
Dirty cover
Clean or replace the cover
At 400V version: Insufficient
Fan runs the wrong direction
Open the unit plug, change the phases L1 and L3
suction or blowing
No suction or blowing
Fan does not run
1. Thermal protection in the motor has switched off
because of overload. Ready for operation after
cooling down (approx. 15 min.)
2.
Check the foot switch
3.
Unscrew the e-box, check the contactor on the
PC-board
Fan motor runs loudly
Impeller dirty and therefore
Clean the impeller
unbalance
(see section “Maintenance and Service”)
10.10.2016
18