Veigel BLF00006, Installation And Operating Instructions Manual

Page: 26 / 36

5-4
Operation
In Mode 2
1. Ignition on
2. Status LED flashes quickly once
(LED indicating that the original
pedal is active is not lit)
(LED indicating that the additional
pedal is active flashes)
3. Press the button within 6 s
to switch the accelerator pedal
(Attention: This can only be done
once,
after that the ignition needs to be
switched off
and on again)
4. If the left-hand accelerator
module is active,
the status LED lights up continu-
ously.
Otherwise, the LED goes out and
the standard accelerator module
is active
5: The most recently active accel-
erator module has been
saved and preselected
for the next start.
Fig. 5-5: Original accelerator pedal active
Fig. 5-6: Additional accelerator active
NOTE
Change operation mode, Mode 1 and Mode 2 are only available after assembly.