Veigel BLF00006, Installation And Operating Instructions Manual

Page: 25 / 36

5-3
Operation
In Mode 1
1. Ignition on
2. Status LED flashes quickly once
(LED indicating that the original
pedal is active is not lit)
3. Press the button within 6 s
to switch the accelerator pedal
(Attention: This can only be done
once,
after that the ignition needs to be
switched off
and on again)
4. If the left-hand accelerator
module is active,
the status LED lights up continu-
ously.
Otherwise, the LED goes out and
the standard accelerator module
is active
Fig. 5-3: Original accelerator pedal active
NOTE
When delivered, the VEA is in Mode 1.
Mode 1 = the original accelerator pedal is active each time the vehicle restarts.
It is possible to set the VEA to Mode 2 instead.
Mode 2 = the last accelerator pedal used remains stored.
Fig. 5-4: Additional accelerator active
If the switchover button lights up but the additional accelerator pedal does
not respond, take the vehicle to a workshop.
ATTENTION!
If the additional accelerator pedal responds incorrectly or with a delay,
stop using the vehicle.
ATTENTION!