8
4 Mounting
External housing • VEGAFLEX 80 series
46802-EN-200212
Tip:
Mount the wall mounting plate in such a way that the cable gland of
the base points downward. Rain and condensation water can thus
drain off.
The base of stainless steel can be displaced in 90° increments on the
wall mounting plate, the base of plastic by 180°.
Turn the cable gland of the electronics housing downward. The hous-
ing can be turned by 330° without the use of any tools.
Warning:
With the plastic housing, the four screws of the base may only be
screwed in hand tight. Exceeding the max. torque specified in chapter
"
Technical data
" can damage the wall mounting plate.
4.4 Mounting - sensor housing
→
Mount the sensor to the bottom, depending on the process fitting
Note:
When mounting the sensor, note the instructions in the operating
instructions manual of the sensor.
