18
4 Mounting
Electronics module • SOLITRAC, MINITRAC, POINTRAC, WEIGHTRAC
40104-EN-210107
1
2
5
Fig. 15: Insert the electronics module carefully into the instrument housing.
1 Housing lid
2 Electronics module
5 Instrument housing
Note:
If the optical pad (4) drops out when inserting the electronics module,
you have to clean the optical pad (4) carefully, grease it again, remove
the grease (only a thin film should remain) and place it again onto the
photomultiplier (8).
22. Press the electronics module (2) carefully down onto the plug
connections.
23. Tighten the four holding screws (7)
24. Plug the already connected terminal blocks (6) carefully onto the
new electronics module (2).
Note:
The terminal blocks are uniquely coded according to the electronics
version.
If one of the terminal blocks does not fit onto the electronics module,
check if you are using the right electronics module.
