VeEX VePAL TX300M, User Manual

Page: 312 / 421

Go back to top Go back to TOC
15.3.2 Results - Standard Mode
The progress and current result of the RFC 2544 can be viewed as the test is in progress.
Results tab:
Navigate the respective sub-tabs (throughput, latency, frame loss, or burst) to view the results for each test. For the burst test,
the results can be viewed in summary table format or test log format.
Status tab:
The status of each test is displayed including a stamped log of each test.
RFC 2544 Results - Status
Go back to top Go back to TOC
Summary tab:
The following results including the Start (ST) and Elapsed (ET) times are displayed:
Line Rate
(Mbps)
:
Negotiated rate of the interface (10M, 100M, or 1000M). This value is always fixed since it depends on
the maximum capacity of the link under test, hence the test interface that is configured.
Framed Rate:
(P MAC/IP VLAN Tag + Type/ CRC) / (P Total Overhead) * Line Rate
% (in Mbps).
Data Rate:
Payload / (P Total Overhead) * Line Rate %.
Utilization:
% of Line Rate. For example, if we transmit 100Mbps on a 1Gbps interface then the utilization value is 10%
(or 100Mbps) of the total link capacity (or Line Rate).
Number of bytes
Pause Frames:
Total number of transmitted and received ethernet pause flow-control frames.
RFC 2544 Results - Summary
TX300S_e-manual_D07-00-064P_RevA00