VeEX VePAL TX300M, User Manual

Page: 268 / 421

15.0 Ethernet
Test mode, test port(s), and network settings are required prior to performing any measurements or applications.
Setup
Test Port Selection
Port Setup
1GE Fiber Port
1GE Copper Port
10GE Port
Measurement Settings
Clock Synchronization Process
MX Discover and Control
OAM Discover
ViPAG Router Test
ViPAG Setup
ViPAG Results
15.1 Ethernet Setup
15.1.1 Test Port Selection
This menu is accessed via the Test Port button located at the top right hand side of the screen. Depending on interface options
purchased, the following selections are possible:
Single port 10GE (10 GE XFP Port 1)
Single Copper port 1GE (1 GE Copper Port 1)
Single Fiber port 1GE (1 GE Fiber Port 1)
Dual port 10GE and Copper 1GE (10 GE XFP Port 1 and 1 GE Copper Port 2)
Dual port 10GE and Fiber 1GE (10 GE XFP Port 1 and 1 GE Fiber Port 2)
Dual Copper port 1GE (1 GE Copper Port 1 and 1 GE Copper Port 2)
Dual Fiber port 1GE (1 GE Fiber Port 1 and 1 GE Fiber Port 2)
Dual Copper Fiber port 1 GE (1 GE Copper Port 1 and 1 GE Fiber Port 1)
Pass Through Monitor Copper 1 GE (1 GE Copper Port 1 and 1 GE Copper Port 2)
Pass Through Monitor Fiber 1 GE (1 GE Fiber Port 1 and 1 GE Fiber Port 2)
After selecting the test interface click
OK
button located at the bottom of the pop-up window.
TX300/e - Test Mode Selection
Go back to top Go back to TOC
15.1.2 Port Setup
TX300S_e-manual_D07-00-064P_RevA00