VeEX VePAL TX300M, User Manual

Page: 276 / 421

Control
The
Control
button becomes available on the right side menu when any Ethernet application (V-SAM, RFC 2544, Throughput, BERT)
is selected. Press the
Control
button to configure loop up and loop down commands necessary to control a far-end unit. The loop up
command contains information about the test layer. Looping back test traffic is possible as follows:
Layer 1:
All incoming traffic is looped back unchanged
Layer 2:
All incoming unicast traffic is looped back with the MAC source and destination addresses swapped
Layers 3 & 4:
All incoming unicast traffic is looped back with MAC/IP source and destination addresses swapped
To configure loopback control on the unit, select from the following options under
Partner Address
:
MX Discovered:
Lists MX discovered devices. Select from the list of discovered devices to loop up/down
User Defined:
Input the destination IP address of the far-end device
OAM Discover
: Lists OAM discovered devices. Select from the list of discovered devices to loop up/down
Remote Partner Control
The
Peer-to-Peer
option is available only for RFC 2544 testing. For more information on
Peer-to-Peer
mode, please see 15.3.1.4
Peer-to-Peer and Asymmetric Testing .
Go back to top Go back to TOC
OAM Discover
TX300S_e-manual_D07-00-064P_RevA00